7 SSI courses

Regulation 10 of the Control of Asbestos Regulations 2012 sets down requirements for asbestos awareness training. Basically, any employer involved in work where there might be a risk of disturbing asbestos, such as general building, maintenance, demolition, or refurbishment, is required by law to ensure that all affected employees are educated and trained appropriately. More recently the importance of adherence to the awareness measures has been emphasised in the Health & Safety Executive’s ‘Duty to Manage Asbestos Enforcement Initiative’ and it is now clear that non-compliance will not be tolerated. In fact, several perpetrators have already been served with improvement notices, or in the worst-case scenario a probation notice, which results in an immediate and costly halt to work. Employee training is believed to be the best way to target the estimated 1.8 million workers who are potentially at risk of life-threatening illnesses following exposure to asbestos in their day-to-day work. These people include plasterers, roofers, plumbers, electricians, demolition, maintenance men and joiners but also the less obvious workers such as computer installers, ground workers, landscapers, and fire & burglar alarm installers. Aims To raise personnel awareness of asbestos and the risks associated with it. To comply with the legal requirement of The Control of Asbestos Regulations 2012. Course Content • Introduction to asbestos - nature and origin • Types of asbestos • Properties and benefits (use of asbestos) • Health hazards • Possible locations of asbestos in buildings • Current legislation and guidance • Legal limitations on work liable to disturb asbestos • Working safely/duty holders’ responsibilities • Safe working in areas where asbestos is present • Decontamination • Emergency procedures/accidental damage/general procedures. Prerequisites None – The course is intended either as an introduction or as an update. Assessment Delegates will be required to complete a short multiple-choice test at the end of the training. Certificate This course is covered by certification to provide to your Clients, CHAS (and other SSIP) as confirmation of training undertaken and is valid for 2 years. Instructions Cost includes: course notes, certification & refreshments. Directions Location Map

This half-day course is a must for all staff, identified as potential or existing Fire Marshals in commercial premises. Not only is this a legal requirement under the Regulatory Reform (Fire Safety) Order 2005, but it also supports your Company if accredited to CHAS or similar SSIP schemes in demonstrating that suitable training has been provided to your staff. Unlike other courses the learners will receive practical firefighting in a controlled environment against an actual fire, where they will pull the pin out of the extinguisher and fight the fire. Aims To give a clear understanding of what to do in the event of a fire, to primarily protect the life of themselves and others and secondly property. Course Content • Aims of fire safety • Fire Prevention • Methods of combustions • Methods of evacuation • Actions on discovering a fire • Means of escape • Fire Growth and Spread • Practical fire fighting Prerequisites None - The course is intended either as an introduction or as a refresher. Assessment At the end of this course, all delegates will have a clear understanding of the knowledge and requirements of being a Fire Marshal. Certificate This course is covered by certification as confirmation of training undertaken and is valid for 3 years. Instructions Cost includes: course notes, certification & refreshments. Directions Location Map

This three-day IOSH (The Institution of Occupational Safety and Health) course is a must for all managers and supervisors in any sector in any organisation. Managing Safely is unlike any other Health & Safety Course. It delivers practical step-by-step guidance with a sharp business focus that is hands-on and jargon-free. The innovative format and content are engaging and inspiring – critical to embedding Health & Safety throughout your entire organisation. Aims To give the knowledge and tools to tackle the Health & Safety issues they are responsible for. Importantly, it brings home just why Health & Safety is such an essential part of their job. Course Content • Introducing Health and Safety • Assessing Risks • Controlling Risks • Identifying Hazards • Investigating Accidents and Incidents • Measuring Performance. Prerequisites None – designed for managers and supervisors. Assessment Written exam at the end of the course with a practical assessment to be completed in the workplace. Certificate This course is covered by certification to provide to your Clients, CHAS (and other SSIP) as confirmation of training undertaken and is valid for 5 years. Instructions Please note: Cost includes course material, certification, lunch & refreshments. Directions Location Map

CWSP training course description A hands-on training course concentrating solely on WiFi security with an emphasis on the delegates learning the necessary knowledge and skills to pass the CWSP exam. The course progresses from simple authentication, encryption and key management onto in depth coverage of 802.X and EAP along with many other security solutions such as access control, intrusion prevention and secure roaming. What will you learn Demonstrate the threats to WiFi networks. Secure WiFi networks. Configure: WPA2 RADIUS 802.1x EAP Pass the CWSP exam. CWSP training course details Who will benefit: Technical network staff. Technical security staff. Prerequisites: Certified Wireless Network Associate. Duration 5 days CWSP training course contents WLAN Security overview Standards, security basics, AAA, 802.11 security history. Hands on WLAN connectivity. Legacy 802.11 security Authentication: Open system, shared key. WEP. VPNs. MAC filters. SSID segmentation, SSID cloaking. Hands on Analysing 802.11 frame exchanges, viewing hidden SSIDs. Encryption Basics, AES, TKIP, CCMP, WPA, WPA2. Hands on Decrypting 802.11 data frames. 802.11 layer 2 authentication 802.1X: Supplicant, Authenticator, Authentication server. Credentials. Legacy authentication. EAP, Weak EAP protocols, Strong EAP protocols: EAP -PEAP, EAP-TTLS, EAP-TLS, EAP-FAST. Hands on Analysing 802.1X/EAP frames. 802.11 layer 2 dynamic key generation Robust Security Network. Hands on Authentication and key management. SOHO 802.11 security WPA/WPA2 personal, Preshared Keys, WiFi Protected Setup (WPS). Hands on PSK mapping. WLAN security infrastructure DS, Autonomous APs, WLAN controllers, split MAC, mesh, bridging, location based access control. Resilience. Wireless network management system. RADIUS/LDAP servers, PKI, RBAC. Hands on 802.1X/EAP configuration. RADIUS configuration. 802.11 Fast secure roaming History, RSNA, OKC, Fast BSS transition, 802.11k. Hands on Roaming. Wireless security risks Rogue devices, rogue prevention. Eavesdropping, DOS attacks. Public access and hotspots. Hands on Backtrack. WiFi security auditing Layer 1 audit, layer 2 audit, pen testing. WLAN security auditing tools. WiFi security monitoring Wireless Intrusion Detection and Prevention Systems. Device classification, WIDS/WIPS analysis. Monitoring. 802.11w. Hands on Laptop spectrum analysers. VPNs, remote access, guest access Role of VPNs in 802.11, remote access, hotspots, captive portal. Wireless security policies General policy, functional policy, recommendations.

CWNA training course description A hands-on course focusing on the technical support of WiFi. Wireless LANs are often seen as simple communications that are simply installed and then left alone to work. This course ensures that delegates will be able to install WiFi networks which work but also enable the delegates to troubleshoot WiFi when it does go wrong. What will you learn Compare 802.11 standards. Configure WiFi networks. Troubleshoot WiFi networks using spectrum analysers, Wireshark and other tools. Implement 802.11 security. Perform RF surveys. CWNA training course details Who will benefit: Technical staff working with WiFi networks. Anyone wishing to pass the CWNA exam. Prerequisites: Intro to data communications & networking Duration 5 days CWNA training course contents Introduction History, standards. RF fundamentals What is RF? Wavelength, Frequency, Amplitude, Phase. Wave behaviour. RF components. Watts, mW, dB, SNR, Link budgets. Hands on Spectrum analysis. Listing WiFi networks. WiFi connection. inSSIDer. Antennas Radiation envelopes, polar charts, gain, Antenna types. Line of Sight, MIMO. Hands on Connecting, installing, changing antennae. RSSI values. 802.11 802.11-2007, 802.11 post 2007, 802.11 drafts. 802.11 b/g/n. Hands on WiFi performance measurement. Spread Spectrum RF frequency bands, FHSS, DSSS, OFDM. Channels. Hands on Configuring channels. Topologies Mesh, Access points, distribution systems, SSID. Hands on AP configuration. Client connection profiles. 802.11 MAC CSMA/CA, Management frames, control frames, data frames. Passive scanning, active scanning. Open system authentication. Shared Key authentication. Association. RTS/CTS. Power management. Hands on Capturing frames, analysing frames. WiFi architecture WiFi client, WLAN architecture: Autonomous, Centralised, distributed. WiFi bridges. WiFi routers. PoE. Hands on WLAN controllers. Troubleshooting RF interference, multipath, adjacent channels, low SNR, mismatched power. Coverage, capacity. 802.11 Security Basics, Legacy security: WEP, MAC filters, SSID cloaking. PSK, 8021.X/EAP, WPA/WPA2. TKIP/ CCMP encryption. Guest WLANs. Wireless attacks, intrusion monitoring. Hands on WEP cracking, WPA2 configuration. RADIUS. RF Site surveys Protocol and spectrum analysis, coverage analysis. Site survey tools. Hands on Performing a site survey.

This one-day course is a must for all construction operatives! Not only is this a legal requirement under CDM 2015, but if your Company is accredited to CHAS or similar SSIP schemes you must be able to demonstrate that suitable training has been provided to your staff. The Construction Design & Management Regulations 2015 (CDM) sets the requirement for all workers to have the right skills, knowledge, training, and experience. Aims To give a clear understanding of Regulations & Legislation that applies to construction work and is an ideal refresher for any operative that has previously completed training in Health & Safety. Course Content Overview of the following regulations: • The Construction Design & Management Regulations 2015 (CDM) • Health & Safety at Work etc. Act 1974 • Work at Height Regulations 2005. • Control of Asbestos Regulations 2012 • Control of Substances Hazardous to Health Regulations 2002 (CoSHH) • Provision and Use of Work Equipment Regulations 1998 (PUWER) • Personal Protective Equipment at Work Regulations 1992 (PPE) Practical training in: • Abrasive Wheels • CoSHH • Working at Height (awareness) • Manual Handling (awareness). Prerequisites None - The course is intended either as an introduction or as a refresher. Assessment At the end of this course, all delegates will have a clear understanding of the requirements of Health and Safety Legislation and their responsibilities to comply with them. Certificate This course is covered by certification to provide to your Clients, CHAS (and other SSIP) as confirmation of training undertaken and is valid for 3 years. Instructions Cost includes: course notes, certification, lunch & refreshments. Directions Location Map

WiFi demystified training course description A concise overview aimed at less technical staff requiring an overview of WiFi networks. The course covers the technologies at a high level allowing delegates to discuss WiFi networks with others recognising the buzzwords used. The course will also allow the delegates to recognise the issues involved in planning and installing WiFi networks as well as securing them. What will you learn Recognise the different WiFi technologies available. Describe the architecture of WiFi networks including the role of Access Points. Recognise the distance limitations of WiFi networks. Describe the buzzwords used in WiFi. Recognise the security issues of WiFi networks. WiFi demystified training course details Who will benefit: Anyone working with WiFi networks. Prerequisites: None. Duration 1 day WiFi demystified training course contents Introduction When to use wireless, when to use wired, WiFi technologies: 802.11, 802.11a, 802.11b, 802.11g, 802.11n, WiFi speeds and distances, comparison to other wireless technologies, 802.15 (Bluetooth), 802.16 (WiMax). Simple WiFi networks Network cards, Antennae, Access Points, WiFi routers. Enterprise WiFi networks SSIDs, Multiple WiFi networks, Repeaters, Wireless bridges, Controller based access points, Wireless switches, Power Over Ethernet. RF site surveys Steps and techniques, tools, analysing the feasibility of WiFi, range, performance, roaming. Security How safe are WiFi networks? Encryption, Authentication, WEP WPA WPA2. 802.1x, EAP, RADIUS.